Θερμοστάτης Ψηφιακός -50~+100°C 5A 230V 2 Πούρα ZFX-ST3012

Θερμοστάτης Ψηφιακός -50~+100°C 5A 230V με 2 αισθητήρες θερμοκρασίας ZFX-ST3012

Κατάλληλο για θέρμανση και φύξη

PRODUCT PARAMETERS AND CHARACTERISTICS

These are two independent thermostats with separate sensors in one controller.
The regulator is designed for automatic temperature control in two places and devices.
Simple and intuitive operation.
The device has a built-in memory of settings. The thermostat does not need to be reprogrammed when power is disconnected.
Clearly visible LED diodes indicate activated relay and activated alarm.
the device has an alarm for exceeding the lower or upper temperature limit.
The alarm is signaled by a sound and a display plus a flashing signaling diode.
Input voltage (supply): AC 230V, the thermostat does not require power.
Relay contacts load capacity: 5A at AC 230V
Temperature measurement: -50°C - +110°C
Temperature measurement resolution: 0.1°C Temperature
refresh rate: 0.5s (very fast) Temperature measurement probe: waterproof (stainless steel)
Applied sensor: NTC10k/343S
Cable length with the probe: 95cm (we have longer ones on offer).
The length of the remaining wires: about 20cm
Probe diameter: 4mm
Probe length: 20mm
Displays: 2x LED 3 digits
Display color: red
Signaling LED color: green/red (relay/alarm)
Housing dimensions without fixings: 76 x 55 x 31mm
Mounting hole spacing: 88mm
Operating temperature: 0°C - 50°C
Weight: 100g
Pins description and manual below on the graphics.
User manual
Thermostat 2 ("up" and "down" buttons under the right display) is programmed in the same way as thermostat 1 ("up" and "down" buttons under the left display).

Thermostat temperature setting 1:

Press SET once, then use the "up" and "down" buttons to set the temperature (holding the button down speeds up the temperature change).
Setting the temperature of the thermostat 2:
Press SET twice, and then use the "up" and "down" buttons to set the temperature (holding the button down speeds up the temperature change).

Thermostat MENU 1:
Press SET once,
Thermostat 2 MENU:
Press SET twice and then hold SET for 2 seconds to enter MENU.
Using the "up" and "down" buttons, select one of several functions available in the MENU.

MENU (setting ranges in brackets):
HC - Heating "H" / Cooling "C".
D - °C difference between the set temperature and the relay activation temperature (1-30°C).
LS - low temperature alarm (from -50°C to +109°C). Alarm signaled by sound, flashing red LED and display "-L-".
HS - high temperature alarm (from -49°C to +110°C). Alarm signaled by sound, flashing red LED and display "-H-".
CA - correction (calibration) of temperature indications (from - 10°C to 10°C).

Press SET to select the desired function, then use "up" and "down" to change the value.
Press SET to return to function selection.
Always after 5 seconds of inactivity (no matter where in the MENU), the device saves the settings and returns to the temperature display.
A flashing red LED means the PT delay time is counting down.